Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell Storage Manager 2020 R1 Administrator's Guide

PDF

Configure iSCSI Ports

For a Storage Center with iSCSI front-end ports, verify iSCSI cabling and then enter network information for the fault domains and ports.

Prerequisites

One port from each controller within the same fault domain must be cabled.

Steps

  1. Review the information on the iSCSI - Cable Ports page. If the Storage Center is not cabled correctly to create fault domains, fix the cabling and click Refresh
  2. Click Next.
    TheSet IPv4 Addresses for iSCSI Fault Domain 1 page opens.
  3. Enter network information for the fault domain and its ports.
    NOTE:Make sure that all the IP addresses for iSCSI Fault Domain 1 are in the same subnet.
  4. Click Next.
  5. On the Set IPv4 Addresses for iSCSI Fault Domain 2 page, enter network information for the fault domain and its ports. Then click Next.
    NOTE:Make sure that all the IP addresses for iSCSI Fault Domain 2 are in the same subnet.
  6. Click Next.
  7. Review the fault domain information.
  8. (Optional) Click Copy to clipboard to copy the fault domain information.
  9. (Optional) Review the information on the Hardware and Cabling Diagram tabs.
  10. Click Next.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\