Dell Storage Manager 2020 R1 Administrator's Guide

Replace a Failed Power Supply

This step-by-step wizard guides you through replacing a failed power supply in an enclosure in the Storage Center.

1. If the Dell Storage Manager Client is connected to a Data Collector, select a Storage Center from the Storage view.
2. Click the Hardware tab.
3. In the Hardware tab navigation pane, expand Enclosures, then select and expand the enclosure with the failed power supply.
   The Enclosure view is displayed.
4. Under the selected enclosure, click Power Supplies.
   The Power Supplies view is displayed.
5. In the right pane, select the failed power supply, then click Replace Power Supply.
   The Replace Failed Power Supply wizard opens.
6. Refer to the graphic in the wizard to locate the failed power supply. Click Next.
7. Follow the instructions to remove the failed power supply. Click Next.
8. Follow the instructions to insert the replacement power supply. Click Next to verify the replacement.
   If this verification fails, an error message is displayed. You can proceed to the next step once the error is corrected and validated.
9. Click Finish to exit the wizard.