Dell EMC SmartFabric OS10 User Guide Release 10.5.0

The add-path command is disabled by default.

1. Assign an AS number in CONFIGURATION mode.

   router bgp as-number

2. Enter a neighbor and IP address (A.B.C.D) in ROUTER-BGP mode.

   neighbor ip-address

3. Enter Address Family mode in ROUTER-NEIGHBOR mode.

   address-family {[ipv4 | ipv6] [unicast])

4. Allow the specified neighbor to send or receive multiple path advertisements in ROUTER-BGP mode. The count parameter controls the number of paths that are advertised — not the number of paths received.

   add-path [both | received | send] count

Enable additional paths

OS10(config)# router bgp 102
OS10(conf-router-bgp-102)# neighbor 32.1.1.2
OS10(conf-router-neighbor)# address-family ipv4 unicast 
OS10(conf-router-bgp-neighbor-af)# add-path both 3