Dell EMC SmartFabric OS10 User Guide Release 10.5.0

To enable OSPFv2 in a non-default VRF instance:

1. Create a non-default VRF instance in which you want to enable OSPFv2:

   ip vrf vrf-name

2. Enable OSPF and configure an OSPF instance in VRF CONFIGURATION mode.

   router ospf instance-number vrf vrf-name

3. Enter the interface information to configure the interface for OSPF in INTERFACE mode.

   interface ethernet node/slot/port[:subport]

4. Enable the interface in INTERFACE mode.

   no shutdown

5. Disable the default switchport configuration and remove it from an interface or a LAG port in INTERFACE mode.

   no switchport

6. Associate the interface with the non-default VRF instance that you created earlier.

   ip vrf forwarding vrf-name

7. Assign an IP address to the interface.

   ip address ip-address/mask

8. Enable OSPFv2 on the interface.

   ip ospf process-id area area-id

   • process-id—Enter the OSPFv2 process ID for a specific OSPF process, from 1 to 65535.
   • area-id—Enter the OSPFv2 area ID as an IP address (A.B.C.D) or number, from 1 to 65535.

Enable OSPFv2 configuration

OS10(config)# ip vrf vrf-blue
OS10(config-vrf-blue)# router ospf 100 vrf-blue
OS10(conf-router-ospf-100)# exit
OS10(config)#  interface ethernet 1/1/2
OS10(conf-if-eth1/1/2)# no shutdown
OS10(conf-if-eth1/1/2)# no switchport
OS10(conf-if-eth1/1/2)# ip vrf forwarding vrf-blue
OS10(conf-if-eth1/1/1)# ip address 11.1.1.1/24
OS10(conf-if-eth1/1/1)# ip ospf 100 area 0.0.0.0