Dell EMC SmartFabric OS10 User Guide Release 10.5.0

• start-time — Sets the initial SPF delay in milliseconds, from 1 to 600000; default 1000.
• hold-time — Sets the additional hold time between two SPF calculations in milliseconds, from 1 to 600000; default 10000.
• max-wait — Sets the maximum wait time between two SPF calculations in milliseconds, from 1 to 600000; default 10000.

• start-time — 1000 milliseconds
• hold-time — 10000 milliseconds
• max-wait — 10000 milliseconds

If you do not specify a start-time, hold-time, or max-wait value, the default values are used. The no version of this command removes the configured SPF timers and disables SPF throttling in an OSPF instance.

OS10(config)# router ospf 100
OS10(config-router-ospf-100)# timers spf 1200 2300 3400
OS10(config-router-ospf-100)# do show ip ospf

Routing Process ospf 100 with ID 12.1.1.1
Supports only single TOS (TOS0) routes
It is Flooding according to RFC 2328
SPF schedule delay 1200 msecs, Hold time between two SPFs 2300 msecs
Convergence Level 0
Min LSA origination 0 msec, Min LSA arrival 1000 msec
Min LSA hold time 5000 msec, Max LSA wait time 5000 msec
Number of area in this router is 1, normal 1 stub 0 nssa 0
Area (0.0.0.1)
Number of interface in this area is 1
SPF algorithm executed 1 times