Dell EMC SmartFabric OS10 User Guide Release 10.5.0

Only BGP route-maps support the continue clause. When a match is found, set clauses run and the packet forwards — no route-map processing occurs. If you configure the continue clause without configuring a module, the next sequential module processes.

If you configure the continue command at the end of a module, the next module processes even after a match is found. The example shows a continue clause at the end of a route-map module — if a match is found in the route-map test module 10, module 30 processes.

Route-map continue clause

OS10(config)# route-map test permit 10
OS10(conf-route-map)# continue 30