Dell EMC SmartFabric OS10 User Guide Release 10.5.0

• process-id — (Optional) Displays information for an OSPF process ID. If you do not enter a process ID, this command applies only to the first OSPF process.
• vrf vrf-name — (Optional) Displays information for an OSPF instance corresponding to a VRF.
• interface — (Optional) Enter the interface information:
  • ethernet — Enter the Ethernet interface information, from 1 to 48.
  • port channel — Enter the port-channel interface number, from 1 to 128.
  • vlan — Enter the VLAN interface number, from 1 to 4093.

OS10# show ip ospf 10 interface
ethernet1/1/1 is up, line protocol is up
  Internet Address 110.1.1.1/24, Area 0.0.0.0
  Process ID 10, Router ID 1.1.1.1, Network Type broadcast, Cost: 10
  Transmit Delay is 1 sec, State WAIT, Priority 1
  BFD enabled(Interface level) Interval 300 Min_rx 300 Multiplier 3 Role Active
  Designated Router (ID) , Interface address 0.0.0.0
  Backup Designated router (ID) , Interface address 0.0.0.0
  Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
  Neighbor Count is 0, Adjacent neighbor count is 0