Dell EMC SmartFabric OS10 User Guide Release 10.5.0

ip pim [vrf vrf-name] bsr-candidate {ethernet node/slot/port[:subport] | loopback loopback-interface-number | vlan vlan-number | port-channel port-channel-number} [hash-mask-len length] [priority priority-value]

no ip pim [vrf vrf-name] bsr-candidate

• vrf vrf-name—Enter the keyword vrf, then the name of the VRF
• loopback-interface-number—Enter a value from 0 to 16383
• vlan-number—Enter a value from 1 to 4093
• port-channel-number—Enter a value from 1 to 128
• length—Enter a value from 0 to 32
• priority-value—Enter a value from 0 to 255

• Hash mask length is 30.
• Priority is 64.

The system advertises the IP address of the specified interface as the BSR IP address in BSR messages. The no form of the command removes the router from being the candidate BSR. Do not specify the parameters in the no form of the command.

OS10# configure terminal
OS10(config)# ip pim vrf red bsr-candidate loopback 10 hash-mask-len 31 priority 11