Dell EMC SmartFabric OS10 User Guide Release 10.5.0

Configuring PBR per VRF

1. Create the match ACL rule for IPv4 or IPv6 traffic.
   {ip | ipv6} access-list access-list-name
2. Permit or deny IPv4 or IPv6 traffic from any source with a specific destination.
   permit {ip | ipv6} any ip-address
   or
   deny {ip | ipv6} any ip–address
3. Configure a route-map to re-direct traffic arriving on a specific VRF instance.
   route-map route-map-name
4. Enter the IPv4 or IPv6 address to match and specify the access-list name.
   match {ip | ipv6} address access-list-name
5. In the route-map, set the IPv4 or IPv6 next-hop to be reached through a different VRF instance.
   set {ip | ipv6} vrf vrf-name next-hop next-hop-ipv4address
   This next-hop-address is reachable through a different VRF instance.

   NOTE If the next-hop is reachable on the specified VRF instance, the packet is redirected; otherwise, the packet follows the regular routing flow.
6. Apply the route-map to the interface.
   interface interface-type
   {ip | ipv6} policy route-map route-map-name
7. View the route-map information.
   show route-map

   OS10(conf-if-vl-40)# do show route-map 
   route-map test, permit, sequence 10
   Match clauses:
   ip address (access-lists): acl1
   Set clauses:
   ip vrf red next-hop 1.1.1.1 track-id 200