Dell EMC SmartFabric OS10 User Guide Release 10.5.0

Create a LAG, and add LAG member interfaces. By default, all interfaces are in no shutdown and switchport modes.

1. Create a LAG in CONFIGURATION mode.

   interface port-channel port-channel number

2. Enter INTERFACE mode.

   interface ethernet node/slot/port[:subport]

3. Set the channel group mode to Active in INTERFACE mode.

   channel-group number mode active

Configure dynamic LAG interfaces

OS10(config)# interface port-channel 10
OS10(conf-if-po-10)# exit
OS10(config)# interface ethernet 1/1/10
OS10(conf-if-eth1/1/10)# no switchport
OS10(conf-if-eth1/1/10)# channel-group 10 mode active
OS10(conf-if-eth1/1/10)# exit
OS10(config)# interface ethernet 1/1/11
OS10(conf-if-eth1/1/11)# no switchport
OS10(conf-if-eth1/1/11)# channel-group 10 mode active