Dell EMC SmartFabric OS10 User Guide Release 10.5.0

• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214.
• A::B — Enter the IPv6 address in hexadecimal format separated by colons.
• A::B/x — Enter the number of bits that must match the IPv6 address.
• any — (Optional) Enter the keyword any to specify any source or destination IP address.
• host ipv6-address — (Optional) Enter the IPv6 address to use a host address only.
• operator — (Optional) Enter a logical operator to match the packets on the specified port number. The following options are available:
  • eq — Equal to
  • gt — Greater than
  • lt — Lesser than
  • neq — Not equal to
  • range — Range of ports, including the specified port numbers.
• ack — (Optional) Set the bit as acknowledgment.
• fin — (Optional) Set the bit as finish—no more data from sender.
• psh — (Optional) Set the bit as push.
• rst — (Optional) Set the bit as reset.
• syn — (Optional) Set the bit as synchronize.
• urg — (Optional) Set the bit set as urgent.
• capture — (Optional) Capture packets the filter processes.
• count — (Optional) Count packets the filter processes.
• byte — (Optional) Count bytes the filter processes.
• dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
• fragment — (Optional) Use ACLs to control packet fragments.
• log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.

OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter’s sequence number.

OS10(config)# ipv6 access-list egress
OS10(conf-ipv6-acl)# seq 5 permit udp any any capture session 1 log