Dell EMC SmartFabric OS10 User Guide Release 10.5.0

Configure Management IP address

To remotely access OS10, assign an IP address to the management port. Use the management interface for out-of-band (OOB) switch management.

1. Configure the management interface from CONFIGURATION mode.

   interface mgmt 1/1/1

2. By default, DHCP client is enabled on the Management interface. Disable the DHCP client operations in INTERFACE mode.

   no ip address dhcp

3. Configure an IPv4 or IPv6 address on the Management interface in INTERFACE mode.

   ip address A.B.C.D/mask

   ipv6 address A:B/prefix-length

4. Enable the Management interface in INTERFACE mode.

   no shutdown

Configure Management interface

OS10(config)# interface mgmt 1/1/1
OS10(conf-if-ma-1/1/1)# no ip address dhcp
OS10(conf-if-ma-1/1/1)# ip address 10.1.1.10/24
OS10(conf-if-ma-1/1/1)# no shutdown