Dell EMC SmartFabric OS10 User Guide Release 10.5.0

Selects a mode to initialize the maximum scalability size. The available options are: scaled L2 MAC address table, scaled L3 routes table, or scaled L3 hosts table.

Syntax

hardware forwarding-table mode {scaled-l2 | scaled-l3-routes | scaled-l3-hosts}

Parameters

• scaled-l2 —Enter the L2 MAC address table size.
• scaled-l3-routes — Enter the L3 routes table size.
• scaled-l3-hosts — Enter the L3 hosts table size.

Defaults

The default parameters vary according to the platform. See UFT modes.

Command Mode

CONFIGURATION

Usage Information

Configure the sizes of internal L2 and L3 forwarding tables for your requirements of the network environment. To apply the changes, reload the switch.

The no version of this command resets the UFT mode to default.

Example

OS10(config)# hardware forwarding-table mode scaled-l3-hosts

Supported Releases

10.3.0E or later