Dell EMC SmartFabric OS10 User Guide Release 10.5.0

Enable OSPFv3 in a non-default VRF instance

1. Create the non-default VRF instance in which you want to enable OSPFv3:
   ip vrf vrf-name
   CONFIGURATION Mode
2. Enable OSPFv3 in the non-default VRF instance that you created earlier and configure an OSPFv3 instance in VRF CONFIGURATION mode.

   router ospfv3 instance-number vrf vrf-name

3. Enter the interface information to configure the interface for OSPFv3 in INTERFACE mode.

   interface ethernet node/slot/port[:subport]

4. Enable the interface in INTERFACE mode.

   no shutdown

5. Disable the default switchport configuration and remove it from an interface or a LAG port in INTERFACE mode.

   no switchport

6. Associate the interface with the non-default VRF instance that you created earlier.

   ip vrf forwarding vrf-name

7. Enable the OSPFv3 on an interface.

   ipv6 ospfv3 process-id area area-id

   • process-id — Enter the OSPFv3 process ID for a specific OSPFv3 process, from 1 to 65535.
   • area-id — Enter the OSPF area ID as an IP address in A.B.C.D format or number, from 1 to 65535.

OS10(config)# ip vrf vrf-blue
OS10(config-vrf-blue)# router ospfv3 100 vrf vrf-blue
OS10(config-router-ospfv3-100)# exit
OS10(config)#  interface ethernet 1/1/2
OS10(conf-if-eth1/1/2)# no shutdown
OS10(conf-if-eth1/1/2)# no switchport
OS10(conf-if-eth1/1/2)# ip vrf forwarding vrf-blue
OS10(conf-if-eth1/1/1)# ipv6 ospfv3 300 area 0.0.0.0