Dell EMC SmartFabric OS10 User Guide Release 10.5.0

• Enable RSTP on each peer node in CONFIGURATION mode.

  spanning-tree mode rstp

Configure RSTP — peer 1

OS10(config)# spanning-tree mode rstp

Configure RSTP — peer 2

OS10(config)# spanning-tree mode rstp

View VLTi-specific STP information

OS10# show spanning-tree virtual-interface
VFP(VirtualFabricPort) of RSTP 1 is Designated Forwarding
Edge port: No (default)
Link type: point-to-point (auto)
Boundary: No, Bpdu-filter: Disable, Bpdu-Guard: Disable, Shutdown-on-Bpdu-Guard-violation: No
Root-Guard: Disable, Loop-Guard: Disable
Bpdus (MRecords) Sent: 11, Received: 7
Interface                                                               Designated
Name                 PortID   Prio   Cost  Sts   Cost  Bridge ID         PortID
----------------------------------------------------------------------------------
VFP(VirtualFabricPort) 0.1     0     1     FWD    0    32768 0078.7614.6062  0.1

View STP virtual interface detail

OS10# show spanning-tree virtual-interface detail 
Port 1 (VFP(VirtualFabricPort)) of RSTP 1 is designated Forwarding
Port path cost 1, Port priority 0, Port Identifier 0.1
Designated root priority: 32768, address: 00:78:76:14:60:62
Designated bridge priority: 32768, address: 00:78:76:14:60:62
Designated port ID: 0.1, designated path cost: 0
Number of transitions to forwarding state: 1
Edge port: No (default)
Link Type: Point-to-Point
BPDU Sent: 15, Received: 5