Dell EMC SmartFabric OS10 User Guide Release 10.5.0

How do I configure a default management route?

Although the default management route was configured during installation, you can use the route add default gw command from the Linux shell to configure the default management IP address for routing. SupportAssist requires the default management route is configured to work properly, as well as DNS configured and a route to a proxy server.

How do I log into the OS10 shell as the system administration?

Use linuxadmin as the username and password to enter OS10 at root level.

Where can I find additional installation information for my specific device?

See the Setup Guide shipped with your device or the platform-specific Installation Guide on the Dell EMC Support page at dell.com/support.