Dell EMC SmartFabric OS10 User Guide Release 10.5.0

• ipv4–address | ipv6–address — (Optional) Enter the IPv4 or IPv6 address of the logging server.
• tcp | udp | tls port-number — (Optional) Send syslog messages using TCP, UDP, or TLS transport to a specified port on a remote logging server, from 1 to 65535.
• severity-level — (Optional) Set the logging threshold severity:
  • log-emerg — System is unusable.
  • log-alert — Immediate action is needed.
  • log-crit — Critical conditions
  • log-err — Error conditions
  • log-warning — Warning conditions
  • log-notice — Normal, but significant conditions (default)
  • log-info — Informational messages
  • log-debug — Debug messages
• vrf {management | vrf-name} — (Optional) Configure the logging server for the management or a specified VRF instance.

System logging to a remote server is not configured. When configured, system messages are sent over UDP to port 514 on a remote logging server by default. System messages of severity-level log-notice and lower are sent.

The tls option requires that a valid security profile is already configured with the logging security-profile command. If you delete the logging security profile, system messages are sent using UDP (default) to a remote syslog server.

Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.5.0.0. Also supported in SmartFabric mode starting in release 10.5.0.1.

OS10(config)# logging server 10.11.86.139 severity log-info

OS10(config)# logging server fda8:6c3:ce53:a890::2 tcp 1468

OS10(config)# logging server 10.11.86.139 vrf management severity log-debug