Dell EMC SmartFabric OS10 User Guide Release 10.5.0

• mode — Enter the privilege mode used to access CLI modes:
  • exec — Accesses EXEC mode.
  • configure — Accesses class-map, DHCP, logging, monitor, openflow, policy-map, QOS, support-assist, telemetry, CoS, Tmap, UFD, VLT, VN, VRF, WRED, and alias modes.
  • interface — Accesses Ethernet, fibre-channel, loopback, management, null, port-group, lag, breakout, range, port-channel, and VLAN modes.
  • route-map — Accesses route-map mode.
  • router — Accesses router-bgp and router-ospf modes.
  • line — Accesses line-vty mode.
• priv-lvl privilege-level — Enter the number of a privilege level, from 2 to 14.
• command-string — Enter the commands supported at the privilege level.

For users assigned to sysadmin, netadmin, and secadmin roles, you cannot configure a privilege level less than 2.

If a command that you associate with a privilege level has a space, enter the command in double quotes ("). If a command does not have a space or if it has keywords separated by a hyphen, double quotes are not required.

The no version of this command removes a command from a privilege level.

OS10(config)# privilege exec priv-lvl 3 "configure terminal"
OS10(config)# privilege configure priv-lvl 3 "interface ethernet"
OS10(config)# privilege interface priv-lvl  "ip address"
OS10(config)# privilege configure priv-lvl 3 route-map
OS10(config)# privilege route-map priv-lvl 3 "set local-preference"