Dell EMC SmartFabric OS10 User Guide Release 10.5.0

• ipv4-address | ipv6-address — Enter an IPv4 or IPv6 address in A.B.C.D/A::B format.
• agent-addr ipv4-address | ipv6-address — Enter the sFlow agent IP address. If you configure two collectors, the agent IP address must be the same for both the collectors.
• collector-port-number — (Optional) Enter the UDP port number, from 1 to 65535. The default is 6343.
• max-datagram-size datagram-size-number — (Optional) Enter max-datagram-size then the size number in bytes, from 400 to 1500. The default is 1400.
• vrf — (Optional) Enter the VRF instance to set the VRF context to the collector IP address. If you do not specify a VRF, the system uses the default VRF.

You must enter a valid and reachable IPv4 or IPv6 address. If you configure two collectors, traffic samples are sent to both. The sFlow agent address is the IPv4 or IPv6 address used to identify the agent to the collector. The no version of this command removes the configured sFlow collector.

If you specify a nondefault VRF, create the VRF first.

OS10(conf)# sflow collector 10.1.1.1 agent-addr 2.2.2.2 6343 max-datagram-size 1500 vrf default

OS10(conf)# sflow collector 10.1.1.1 agent-addr 2.2.2.2 6343 max-datagram-size 1500 vrf vrf-core