Dell EMC SmartFabric OS10 User Guide Release 10.5.0

Configure match criterion for a route-map. There is no limit to the number of match commands per route map, but keep the number of match filters in a route-map low. The set commands do not require a corresponding match command.

• Match routes with a specific metric value in ROUTE-MAP mode, from 0 to 4294967295.

  match metric metric-value

• Match routes with a specific tag in ROUTE-MAP mode, from 0 to 4294967295.

  match tag tag-value

• Match routes whose next hop is a specific interface in ROUTE-MAP mode.

  match interface interface

  • ethernet — Enter the Ethernet interface information.
  • port-channel — Enter the port-channel number.
  • vlan — Enter the VLAN ID number.

Check match routes

OS10(config)# route-map test permit 1
0S10(conf-route-map)# match tag 250000
OS10(conf-route-map)# set weight 100