Dell EMC SmartFabric OS10 User Guide Release 10.5.0

Use the show configuration command to view the configuration of the interface.

OS10(conf-if-vl-40)# show configuration
!
interface vlan40
no shutdown
ip policy route-map test

Use the show route-map command to view the route-map configuration.

OS10(config)# do show route-map
 route-map map1, permit, sequence 10
 Match clauses:
    ipv6 address (access-lists): acl1
 Set clauses:
    ipv6 vrf {vrf-name} next-hop 5555::5556

OS10(conf-if-vl-40)# do show route-map 
route-map test, permit, sequence 10
Match clauses:
ip address (access-lists): acl1
Set clauses:
ip next-hop 1.1.1.1 track-id 200

OS10(conf-if-vl-40)# do show route-map test 
route-map test, permit, sequence 10
Match clauses:
ip address (access-lists): acl1
Set clauses:
ip vrf red next-hop 1.1.1.1 track-id 200
!