Dell EMC SmartFabric OS10 User Guide Release 10.5.0

ROUTER-NEIGHBOR

ROUTER-TEMPLATE

• Use the bfd command to configure BFD sessions with a specified neighbor or neighbors which inherit a BGP template. Use the neighbor {ip-address | ipv6-address} command in ROUTER-BGP mode to specify the neighbor. Use the template template-name command in ROUTER-BGP mode to specify a BGP template. Use the no bfd command in ROUTER-NEIGHBOR mode to disable BFD sessions with a neighbor.
• Use the bfd all-neighbors command to configure L3 protocol-specific BFD parameters for all BFD sessions between discovered neighbors. The BFD parameters you configure override the global session parameters configured with the bfd interval command.

OS10(conf)# router bgp 1
OS10(config-router-bgp-1)# neighbor 10.1.1.1 
OS10(config-router-neighbor)# bfd
OS10(config-router-neighbor)# no shutdown

OS10(config)# router bgp 300
OS10(config-router-bgp-300)# template ebgppg
OS10(config-router-template)# bfd
OS10(config-router-template)# exit
OS10(config-router-bgp-300)# neighbor 3.1.1.1
OS10(config-router-neighbor)# inherit template ebgppg
OS10(config-router-neighbor)# no shutdown