Dell EMC SmartFabric OS10 User Guide Release 10.5.0

Enable OSPFv3

1. Enable OSPFv3 globally and configure an OSPFv3 instance in CONFIGURATION mode.

   router ospfv3 instance-number

2. Enter the interface information to configure the interface for OSPFv3 in INTERFACE mode.

   interface ethernet node/slot/port[:subport]

3. Enable the interface in INTERFACE mode.

   no shutdown

4. Disable the default switchport configuration and remove it from an interface or a LAG port in INTERFACE mode.

   no switchport

5. Enable the OSPFv3 on an interface in INTERFACE mode.

   ipv6 ospfv3 process-id area area-id

   • process-id — Enter the OSPFv3 process ID for a specific OSPFv3 process, from 1 to 65535.
   • area-id — Enter the OSPF area ID as an IP address in A.B.C.D format or number, from 1 to 65535.

OS10(config)# router ospfv3 100
OS10(config-router-ospfv3-100)# exit
OS10(config)#  interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# no shutdown
OS10(conf-if-eth1/1/1)# no switchport
OS10(conf-if-eth1/1/1)# ipv6 ospfv3 300 area 0.0.0.0