Dell EMC SmartFabric OS10 User Guide Release 10.5.0

ip pim [vrf vrf-name] rp-candidate {ethernet node/slot/port[:subport] | loopback loopback-interface-number | vlan vlan-number | port-channel port-channel-number} [priority priority-value] [acl acl-name]

• vrf vrf-name—Enter the keyword vrf, then the name of the VRF
• loopback-interface-number—Enter a value from 0 to 16383
• vlan-number—Enter a value from 1 to 4093
• port-channel-number—Enter a value from 1 to 128
• priority-value—Enter a value from 0 to 255
• acl-name—Standard ACL name

Specify the interface to obtain the candidate RP address. The access-list acl-name adds a range of group addresses that this candidate RP can serve.

If you do not specify an access list, the C-RP advertises itself to the entire multicast range, 224.0.0.0./4.

If you specify an access list, the C-RP advertises only the group range that the access list permits.

The no form of the command removes the router from being a C-RP. You must specify the parameters with the no form of this command.

OS10# configure terminal
OS10(config)# ip pim vrf red rp-candidate loopback 10 priority 11 acl rp-grp