Dell EMC OpenManage Command Line Interface Guide Version 9.1


Omconfig cancel check consistency

Table 1. omconfig cancel check consistency . The following table describes the syntax and sample syntaxes for the omconfig cancel check consistency command.


Cancels a check consistency while in progress.


omconfig storage vdisk action=cancelcheckconsistency controller=id vdisk=id , where id is the controller ID and virtual disk ID as reported by the omreport command.

  • NOTE: To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage vdisk controller=ID to display the IDs for the virtual disks attached to the controller.

Example to

Cancel a check consistency on virtual disk 4 on controller 1.


omconfig storage vdisk action=cancelcheckconsistency controller=1 vdisk=4

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\