Dell EMC OpenManage Command Line Interface Guide Version 9.1


Omconfig Resume Check Consistency

Table 1. Omconfig Resume Check Consistency. The following table describes the syntax and sample syntaxes for the omconfig Resume Check Consistency command.


Resumes a check consistency after it has been paused.


omconfig storage vdisk action=resumecheckconsistency controller=id vdisk=id , where id is the controller ID and virtual disk ID as reported by the omreport command.

  • NOTE: To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage vdisk controller=ID to display the IDs for the virtual disks attached to the controller.

Example to

Resume a check consistency on virtual disk 4 on controller 1.


omconfig storage vdisk action=resumecheckconsistency controller=1 vdisk=4

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\