Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Set Check Consistency Rate

Table 1. Omconfig Set Check Consistency Rate. The following table describes the process to set the check consistency rate.

Description

Sets the check consistency rate.

Syntax

omconfig storage controller action= setcheckconsistencyrate controller=id rate=<0 to 100> , where id is the controller ID as reported by the omreport storage controller command.

Example to

Sets the check consistency rate to 50 on controller 1.

Example

omconfig storage controller action= setcheckconsistencyrate controller=1 rate=50


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\