Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Cancel Replace Member

Table 1. omconfig Cancel Replace Member . The following table describes the syntax and sample syntaxes for the omconfig Cancel Replace Member command.

Description

Cancels a replace member operation.

Syntax

omconfig storage pdisk action=cancelreplacemember controller=id pdisk=< PDISKID> , where id is the controller ID. The <PDISKID> variable specifies the physical disk.

  • NOTE: To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage pdisk controller=ID to display the IDs for the physical disks attached to the controller.

Example to

Cancel replace member operation on disk 0:0:1 which is connected to controller 0

Example

omconfig storage pdisk action=cancelreplacemember controller=0 pdisk=0:0:1


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\