Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Rescan Controller

Table 1. Omconfig Rescan Controller. The following table describes the process to rescan a controller.

Description

Rescans a controller. For more information, see the Dell EMC OpenManage Online Help .

Syntax

omconfig storage controller action=rescan controller=id , where id is the controller ID as reported by the omreport storage controller command.

Example to

Rescan controller 1.

Example

omconfig storage controller action=rescan controller=1

  • NOTE: The rescan controller is not supported on non-RAID SCSI and SAS controllers. Reboot the system to make the configuration changes visible on non-RAID SCSI controllers.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\