Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Set Reconstruct Rate

Table 1. Omconfig Set Reconstruct Rate . The following table describes the process to set the reconstruct rate.

Description

Sets the reconstruct rate.

Syntax

omconfig storage controller action= setreconstructrate controller=id rate=<0 to 100> , where id is the controller ID as reported by the omreport storage controller command.

Example to

Set the reconstruct rate to 50 on controller 1.

Example

omconfig storage controller action= setreconstructrate controller=1 rate=50


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\