Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Reset Controller Configuration

Table 1. Omconfig Reset Controller Configuration. The following table describes the process to reset the controller configuration.

Description

Resets the controller configuration.

  • CAUTION: Resetting a configuration permanently destroys all data on all virtual disks attached to the controller. System or boot partition residing on these virtual disks is destroyed. You may receive a warning message if this command results in deleting the system or boot partition. However, this warning message is not generated always. Ensure that you do not delete the system or boot partition or other vital data when using this command.

Syntax

omconfig storage controller action=resetconfig controller=id , where id is the controller ID as reported by the omreport storage controller command.

In some circumstances, you may receive a warning message if this command deletes the system or boot partition. You can override this warning by using the force=yes parameter. In this case, the syntax is as follows:
omconfig storage controller action=resetconfig
                                                   controller=id force=yes
                                                

Example to

Reset the configuration on controller 1.

Example

omconfig storage controller action=resetconfig controller=1


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\