跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

auto-cost

Specify how the OSPF interface cost is calculated based on the reference bandwidth method.

Syntax

auto-cost [reference-bandwidth ref-bw]

To return to the default bandwidth or to assign cost based on the interface type, use the no auto-cost [reference-bandwidth ref-bw] command.

Parameters

ref-bw

(OPTIONAL) Specify a reference bandwidth in megabits per second. The range is from 1 to 4294967. The default is 100 megabits per second .

Defaults

100 megabits per second.

Command Modes

ROUTER OSPFv3

Supported Modes

Full-Switch

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.9(0.0)	Introduced on the FN IOM
9.9(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

Example

Dell#show running-config ospf 
                                             !
                                             ipv6 router ospf 10
                                             log-adjacency-changes
                                             auto-cost reference-bandwidth 2000
                                             
                                             Dell(conf-ipv6-router_ospf)#auto-cost reference-bandwidth ?
                                             <1-4294967>             Reference bandwidth in Mbits/second (default = 100)
                                             Dell(conf-ipv6-router_ospf)#no auto-cost ?
                                             reference-bandwidth     Use reference bandwidth method to assign OSPF cost
                                             <cr>
                                             Dell(conf-ipv6-router_ospf)#