跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

neighbor filter-list

Configure a BGP filter based on the AS-PATH attribute.

Syntax

neighbor [ ipv6-address | peer-group-name] filter-list aspath access-list-name [in | out]

To delete a BGP filter, use the no neighbor [ ipv6-address | peer-group-name] filter-list aspath access-list-name [in | out] command.

Parameters

ipv6-address	Enter the IPv6 address in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name	Enter the name of the peer group to apply the filter to all routers in the peer group.
access-list-name	Enter the name of an established AS-PATH access list. If the AS-PATH access list is not configured, the default is permit (to allow routes).
in	Enter the keyword `in` to filter inbound BGP routes.
out	Enter the keyword `out` to filter outbound BGP routes.

Defaults

Not configured.

Command Modes

ROUTER BGPV6-ADDRESS FAMILY

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.