跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip ssh cipher

Configure the list of ciphers supported on both SSH client and SCP.

Syntax

ip ssh cipher cipher-list

Parameters

cipher cipher-list

Enter the keyword cipher and then a space-delimited list of ciphers that the SSH client supports. The following ciphers are available.

aes256-ctr
aes256-cbc
aes192-ctr
aes192-cbc
aes128-ctr
aes128-cbc
3des-cbc

Defaults

The default list of ciphers is in the order as shown below:

aes256-ctr
aes256-cbc
aes192-ctr
aes192-cbc
aes128-ctr
aes128-cbc
3des-cbc

Command Modes

CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide.

Version	Description
9.10(0.0)	Introduced on the S6100–ON, S6000, S6000–ON, S5000, S4810, S4820T, S3048–ON, S4048–ON, MXL, C9010, S3100 series, and Z9100-ON.

Usage Information

You can select one or more ciphers from the list.
The default list of supported ciphers is same irrespective of whether FIPS mode is enabled or disabled.
Client-supported cipher list gets preference over the server-supported cipher list in selecting the cipher for the SSH session.
When the cipher (-c) option is used with the SSH CLI, it overrides the configured or default cipher list.
When FIPS is enabled or disabled, the client ciphers get default configuration.