跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

distance bgp

Configure three administrative distances for routes.

Syntax

distance bgp external-distance internal-distance local-distance

To return to default values, use the no distance bgp command.

Parameters

external-distance	Enter a number to assign to routes learned from a neighbor external to the AS. The range is from 1 to 255. The default is 20.
internal-distance	Enter a number to assign to routes learned from a router within the AS. The range is from 1 to 255. The default is 200.
local-distance	Enter a number to assign to routes learned from networks listed in the network command. The range is from 1 to 255. The default is 200.

Defaults

external-distance = 20
internal-distance = 200
local-distance = 200

Command Modes

ROUTER BGPV6-ADDRESS FAMILY

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

CAUTION: Dell Networking recommends that you do not change the administrative distance of internal routes. Changing the administrative distances may cause routing table inconsistencies.

The higher the administrative distance assigned to a route means that your confidence in that route is low. Routes assigned an administrative distance of 255 are not installed in the routing table.

Routes from confederations are treated as internal BGP routes.