跳转至主要内容
退出

欢迎访问戴尔

我的帐户
  • 快速、轻松地下订单
  • 查看订单并跟踪您的发货状态
  • 创建并访问您的产品列表
  • 使用“Company Administration”（公司管理），管理Dell EMC站点、产品和产品级联系人。
登录 创建帐户 登录Premier 合作伙伴计划登录
联系我们

您的 Dell.com 购物车

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip unnumbered

Configure a tunnel interface to operate without a unique explicit IPv4 address and select the interface from which the tunnel will borrow its address.

Syntax ip unnumbered {interface-type interface-number}

Use the no ip unnumbered command to set the tunnel back to default logical address. If the tunnel was previously operational, this will make the tunnel interface operationally down, unless the tunnel also has an IPv6 address configured..

Parameters
interface-type interface-number

Enter the interface type, followed by a slot number.

Defaults None
Command Modes INTERFACE TUNNEL
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Introduced on the MXL.
Usage Information
The ip unnumbered command will fail in two condition:
  • If the logical ip address is configured.
  • If the tunnel mode is ipv6ip (where ip address over tunnel interface is not possible).

To ping the unnumbered tunnels the logical address route information should be present in both the ends.

  • NOTE: The ip unnumbered command can specify an interface name that does not yet exist, or does not yet have a configured IPv6 address. The tunnel interface is not changed to the operationally up state until logically ip address is identified from the one of the address family.

对此内容评级

准确性
有用性
易理解性
这篇文章对您有帮助吗？
0/3000 characters
  请提供评级（1-5星）。
  请提供评级（1-5星）。
  请提供评级（1-5星）。
  请选择这篇文章是否有帮助。
  注释中不得包含以下特殊字符：<>()\