跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

neighbor peer-group passive

Enable passive peering on a BGP peer group, that is, the peer group does not send an OPEN message, but responds to one.

Syntax

neighbor peer-group-name peer-group passive [limit sessions]

To delete a passive peer-group, use the no neighbor peer-group-name peer-group passive command.

Parameters

peer-group-name	Enter a text string up to 16 characters long as the name of the peer group.
limit	(Optional) Enter the keyword `limit` to constrain the numbers of sessions for this peer-group. The range is from 2 to 256. The default is 256.

Defaults

Not configured.

Command Modes

ROUTER BGP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

After you configure a peer group as passive, assign it a subnet using the neighbor soft-reconfiguration inbound command.

For passive eBGP limits, the Remote AS must be different from the AS for this neighbor.

Related Commands

neighbor soft-reconfiguration inbound — assigns a subnet to a dynamically configured BGP neighbor.

neighbor remote-as — assigns an indirectly connected AS to a neighbor or peer group.