跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

cam-acl-egress

Allocate space for IPv6 egress ACLs.

Syntax

cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}

Parameters

default	Use the default CAM profile settings, and set the CAM as follows: L2 ACL(l2acl): 1 L3 ACL (ipv4acl: 1 IPv6 L3 ACL (ipv6acl): 2
l2acl 1-4 ipv4acl 1- 4 ipv6acl 0-4	Allocate space to support IPv6 ACLs. Enter all of the profiles and a range. Enter the CAM profile name then the amount to be allotted. The total space allocated must equal 13. The `ipv6acl` range must be a factor of 2.

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

For the new settings to take effect, save the new CAM settings to the startup-config ( write-mem or copy run start), then reload the system.

The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and these blocks cannot be reallocated.

When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.

Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).

Example

Dell#
                                             Dell#configure
                                             Dell(conf)#cam-acl-egress ?
                                             default      Reset Egress CAM ACL entries to default setting
                                             l2acl        Set L2-ACL entries
                                             Dell(conf)#cam-acl-egress l2acl ?
                                             <1-4>        Number of FP blocks for l2acl
                                             Dell(conf)#cam-acl-egress l2acl 1 ?
                                             ipv4acl      Set IPV4-ACL entries
                                             Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ?
                                             ipv6acl      Set IPV6-ACL entries
                                             Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ?
                                             <0-4>        Number of FP blocks for IPV6 (multiples of 2)
                                             Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2