跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip ospf hello-interval

Specify the time interval between the hello packets sent on the interface.

Syntax

ip ospf hello-interval seconds

To return to the default value, use the no ip ospf hello-interval command.

Parameters

seconds

Enter the number of seconds for the interval. The range is from 1 to 65535. The default is 10 seconds.

Defaults

10 seconds

Command Modes

INTERFACE

Supported Modes

Full—Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The time interval between the hello packets must be the same for routers in a network.

Related Commands

ip ospf dead-interval — sets the time interval before a router is declared dead.