跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip igmp snooping last-member-query-interval

The last member query interval is the maximum response time inserted into Group-Specific queries sent in response to Group-Leave messages.

Syntax

ip igmp snooping last-member-query-interval milliseconds

To return to the default value, use the no ip igmp snooping last-member-query-interval command.

Parameters

milliseconds

Enter the interval in milliseconds. The range is from 100 to 65535. The default is 1000 milliseconds.

Defaults

1000 milliseconds

Command Modes

INTERFACE VLAN

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
9.2(0.0)	Introduced on the M I/O Aggregator.

Usage Information

This last-member-query-interval is also the interval between successive Group-Specific Query messages. To change the last-member-query interval, use this command.