跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

interface

Configure a physical interface on the switch.

Syntax

interface interface

Parameters

interface

Enter one of the following keywords and slot/port or number information:

For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

Defaults

Not configured.

Command Modes

CONFIGURATION

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage Information

You cannot delete a physical interface.

By default, physical interfaces are disabled ( shutdown) and are in Layer 3 mode. To place an interface in mode, ensure that the interface’s configuration does not contain an IP address and enter the Port Channel Commands command. By default, the interface is shut down when the portmode hybrid and switchport are enabled.

The tunnel interface operates as an ECMP (equal cost multipath) only when the next hop to the tunnel destination is over a physical interface. If you select any other interface as the next hop to the tunnel destination, the tunnel interface does not operate as an ECMP.

Example

Dell(conf)#interface tengig 0/1
                                             Dell(conf-if-te-0/1)#exit#

Related Commands

interface port-channel — configures a port channel.

interface vlan — configures a VLAN.