跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

lacp ungroup member-independent

Prevent possible loop during the bootup of a VLT peer switch or a device that accesses the VLT domain.

Syntax

lacp ungroup member-independent {vlt | port-channel}

Parameters

port-channel	Force all LACP port-channel members to become switchports.
vlt	Force all VLT LACP members to become switchports.

Defaults

Not configured.

Command Modes

CONFIGURATION

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
9.2(0.0)	Supported on the M I/O Aggregator.

Usage Information

LACP on the VLT ports (on a VLT switch or access device), which are members of the virtual link trunk, is not brought up until the VLT domain is recognized on the access device.

To ungroup the VLT and port-channel configurations, use the no lacp ungroup member independent command on a VLT port channel, depending on whether the port channel is VLT or non-VLT.

Example

Dell(conf)#lacp ungroup member-independent ?
                                             port-channel 				LACP port-channel members become switchports
                                             vlt								All VLT LACP members become switchports