跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

match interface

To match routes whose next hop is on the interface specified, configure a filter.

Syntax

match interface interface

To remove a match, use the no match interface interface command.

Parameters

interface

Enter the following keywords and slot/port or number information:

For the Loopback interface, enter the keyword loopback then a number from zero (0) to 16383.
For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.
For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

Defaults

Not configured.

Command Modes

ROUTE-MAP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.0	Introduced on the MXL 10/40GbE Switch IO Module.

Related Commands

match ip address — redistributes routes that match an IP address.

match ip next-hop — redistributes routes that match the next-hop IP address.

match ip route-source — redistributes routes that match routes advertised by other routers.

match metric — redistributes routes that match a specific metric.

match route-type — redistributes routes that match a route type.

match tag — redistributes routes that match a specific tag.