跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip msdp peer

Configure an MSDP peer.

Syntax

ip msdp peer peer address [connect-source] [description] [sa-limit number]

To remove the MSDP peer, use the no ip msdp peer peer address [connect-source interface] [description name] [sa-limit number] command.

Parameters

peer address	Enter the peer address in a dotted decimal format (A.B.C.D.).
connect-source interface	Enter the keywords `connect-source` then one of the interfaces and slot/port or number information: For a Loopback interface, enter the keyword `loopback` then a number from 0 to 16383. For a Port Channel interface, enter the keywords `port-channel` then a number. The range is from 1 to 128. For a 10-Gigabit Ethernet interface, enter the keyword `TenGigabitEthernet` then the slot/port information. For a VLAN, enter the keyword `vlan` then a number from 1 to 4094.
description name	(OPTIONAL) Enter the keyword description then a description name (maximum 80 characters) to designate a description for the MSDP peer.
sa-limit number	(OPTIONAL) Enter the maximum number of SA entries in SA-cache. The range is from 1 to 500000. The default it 500000.

Defaults

As described in the Parameters section.

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The connect-source option is used to supply a source IP address for the TCP connection. When an interface is specified using the connect-source option, the primary configured address on the interface is used.

If the total number of SA messages received from the peer is already larger than the limit when this command is applied, those SA messages continue to be accepted. To enforce the limit in such situation, use the clear ip msdp peer command to reset the peer.

Related Commands

ip msdp sa-limit — configures the MSDP SA Limit.

clear ip msdp peer — clears the MSDP peer.

show ip msdp — displays the MSDP information.