跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ip fib stack-unit

View all FIB entries.

Syntax

show ip fib stack-unit 0–5 [ ip-address [ mask] [longer-prefixes] | summary]

Parameters

0–5	Enter the unit ID, from 0 to 5.
ip-address mask	(OPTIONAL) Enter the IP address of the network destination to view only information on that destination. Enter the IP address in dotted decimal format (A.B.C.D). Enter the mask in slash prefix format (/X).
longer-prefixes	(OPTIONAL) Enter the keywords `longer-prefixes` to view all routes with a common prefix.
summary	(OPTIONAL) Enter the keyword `summary` to view the total number of prefixes in the FIB.

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The following describes the show ip fib stack-unit command shown in the following example.

Field	Description
Destination	Lists the destination IP address.
Gateway	Displays either the word “direct” and an interface for a directly connected route or the remote IP address used to forward the traffic.
First-Hop	Displays the first hop IP address.
Mac-Addr	Displays the MAC address.
Port	Displays the egress-port information.
VId	Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed.
EC	Displays the number of ECMP paths.

Example

Dell#show ip fib stack-unit 0
                                             
                                             Destination    Gateway     First-Hop  Mac-Addr        Port VId EC
                                             ------------------------------------------------------------------ 
                                             10.10.10.10/32 Direct, Nu 0  0.0.0.0 00:00:00:00:00:00 BLK HOLE 0 0
                                             
                                             Dell>

Related Commands

clear ip fib stack-unit — clear FIB entries on a specified stack-unit.