跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show stack-unit stack-ports pfc details

Displays the PFC configuration applied to ingress traffic on stacked ports, including PFC Operational mode on each unit with the configured priorities, link delay, and number of pause packets sent and received.

Syntax

show stack-unit {all | stack-unit} stack-ports {all | port-number} pfc details

Parameters

stack-unit	Enter the stack unit.
port-number	Enter the port number.

Command Modes

CONFIGURATION

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
9.2(0.0)	Introduced on the M I/O Aggregator.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Example

Dell(conf)# show stack-unit all stack-ports all pfc details
                                             
                                             stack unit 0 stack-port all
                                             Admin mode is On
                                             Admin is enabled, Priority list is 4-5
                                             Local is enabled, Priority list is 4-5
                                             Link Delay 45556 pause quantum
                                             0 Pause Tx pkts, 0 Pause Rx pkts
                                             
                                             stack unit 1 stack-port all
                                             Admin mode is On
                                             Admin is enabled, Priority list is 4-5
                                             Local is enabled, Priority list is 4-5
                                             Link Delay 45556 pause quantum
                                             0 Pause Tx pkts, 0 Pause Rx pkts