跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

protocol lldp (Interface)

Enter the LLDP protocol in the INTERFACE mode.

Syntax

[no] protocol lldp

To return to the global LLDP configuration mode, use the no protocol lldp command from Interface mode.

Defaults

Enabled

Command Modes

INTERFACE (conf-if- interface-lldp)

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage Information

This command is available only in PMUX mode.

By default, protocol lldp is enabled, To disable, use the no protocol lldp command.

When you enter the LLDP protocol in the Interface context, it overrides global configurations. When you execute the no protocol lldp from INTERFACE mode, interfaces begin to inherit the configuration from global LLDP CONFIGURATION mode.