跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show system stack-unit iom-mode

Displays the current iom-mode (stack/standalone) and the mode configured after next reboot.

Syntax

show system stack-unit unit-number iom-mode

Parameters

unit number <0–5>

Enter the number of the member stack unit. The range is from 0 to 5.

Command Modes

EXEC Privilege

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.6.(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage information

This command is supported on the M I/O, FN410S, and FN410T Aggregators

Example

Dell#show system stack-unit all iom-mode ?
                                             |                  Pipe through a command
                                             <cr>
                                             Dell#show system stack-unit all iom-mode
                                             Unit       Boot-Mode             Next-Boot
                                             ------------------------------------------------
                                             0           stack                 stack
                                             1           stack                 stack
                                             2           stack                 stack
                                             3           stack                 stack
                                             4       Not Present
                                             5       Not Present
                                             Dell#