跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

passive-interface

Suppress routing updates on an interface. This command stops the router from sending updates on that interface.

Syntax

passive-interface interface

To delete a passive interface configuration, use the no passive-interface interface command.

Parameters

interface

Enter the following keywords and slot/port or number information:

For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/port information.
For Loopback interface, enter the keyword loopback then a number from 0 to 16383.
For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.
For a SONET interface, enter the keyword sonet then the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
For a VLAN, enter the keyword vlan then a number from 1 to 4094.

Defaults

Not configured.

Command Modes

ROUTER ISIS

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

Although the passive interface does not send nor receive routing updates, the network on that interface is still included in the IS-IS updates sent using other interfaces.