跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

stack-unit port-group port mode ethernet

Converts the interfaces 9 and 10 from Fibre Channel mode to Ethernet.

Syntax

stack-unit unit number port-group 0 portmode ethernet

To convert the interfaces 9 and 10 from Ethernet to Fibre Channel mode, use the no stack-unit unit number port-group 0 portmode ethernet.

Parameters

stack-unit	Enter the keyword `stack-unit` followed by a stack member number to select the stack unit. The range is 0 to 5.
port-group	Enter the keyword `port-group` followed by 0.
portmode ethernet	Enter the keyword `portmode ethernet` to convert the interfaces from Fibre Channel mode to Ethernet.

Command Modes

CONFIGURATION

Supported Modes

All Modes

Command History

Version	Description
9.6(0.0)	Supported on the FN2210S Aggregator.